Experimental Performance Analysis of an Electromagnetic Energy Harvester Driven by Flow-Induced Vibration
DOI:
https://doi.org/10.22373/ekw.v12i1.33750Keywords:
electromagnetic energy harvesting, flow-induced vibration, vortex-induced vibration, airflow velocity, structural vibrationAbstract
Abstract: This study aims to experimentally investigate the performance of an electromagnetic energy harvester driven by flow-induced vibration (FIV) under airflow conditions representative of building ventilation systems. A cylindrical oscillator integrated with a magnet–coil transduction mechanism was tested in a wind tunnel at airflow velocities of 0.5 m/s, 2 m/s, and 4 m/s. Vibration responses were measured using an FFT analyzer, while the electrical output was recorded using a digital oscilloscope and processed to obtain RMS voltage and average power. The results show that the harvested power at 2 m/s is approximately four times that obtained at 0.5 m/s, indicating optimal performance within the lock-in region, where the vortex-shedding frequency approaches the structure's natural frequency. Although higher airflow velocity increases the vibration amplitude, the average harvested power at 4 m/s decreases due to partial detuning and increased damping. These findings demonstrate that moderate airflow velocities provide optimal operating conditions for electromagnetic energy harvesting and highlight the feasibility of integrating airflow-based vibration energy harvesters into building systems to power low-energy devices.
Abstrak: Penelitian ini bertujuan untuk mengkaji secara eksperimental kinerja pemanen energi elektromagnetik yang digerakkan oleh getaran akibat aliran fluida (flow-induced vibration) pada kondisi aliran udara yang merepresentasikan sistem ventilasi bangunan. Sebuah silinder elastis yang terintegrasi dengan mekanisme transduksi magnet–kumparan diuji di dalam terowongan angin pada kecepatan aliran 0,5 m/s, 2 m/s, dan 4 m/s. Respons getaran diukur menggunakan FFT analyzer, sedangkan keluaran listrik direkam menggunakan osiloskop digital dan dianalisis untuk memperoleh tegangan RMS serta daya rata-rata. Hasil penelitian menunjukkan bahwa daya yang dihasilkan pada kecepatan 2 m/s sekitar empat kali lebih besar dibandingkan dengan 0,5 m/s, yang menunjukkan kondisi operasi optimal pada daerah lock-in ketika frekuensi pelepasan pusaran mendekati frekuensi alami struktur. Meskipun peningkatan kecepatan aliran memperbesar amplitudo getaran, daya rata-rata pada 4 m/s menurun akibat efek detuning parsial dan peningkatan redaman sistem. Temuan ini menunjukkan bahwa kecepatan aliran sedang merupakan kondisi optimal untuk pemanenan energi elektromagnetik serta menegaskan potensi integrasi sistem ini pada infrastruktur bangunan untuk menyuplai perangkat berdaya rendah.
References
Andriansyah, F., Indah, N., & Subekti, S. (2024). Harvesting energy vibration derived from the rotational speed of a 4-stroke engine. JTTM: Jurnal Terapan Teknik Mesin, 5(1), 67-74.
Boylestad, R. L., & Nashelsky, L. (2011). Electronic devices and circuit theory. Pearson.
Chassaing, P. (2023). Fundamentals of fluid mechanics. Springer: Berlin/Heidelberg, Germany.
Chung, M. H., Yoo, S., Jung, W. N., Jeong, H., & Yoo, K. H. (2023). Self-powered airflow sensor based on energy harvesting of ventilation air in buildings. Advanced Fiber Materials, 5(5), 1788-1798.
Dai, H., Abdelkefi, A., & Wang, L. (2024). Nonlinear dynamics and synchronization enhancement in vortex-induced vibration energy harvesters. Nonlinear Dynamics, 111, 13455–13472. https://doi.org/10.1007/s11071-023-09187-6
Djanali, V. S. (2024). Identification of a nonlinear system for an elastically supported cylinder on cross-flow using wavelet transform. Jordan Journal of Mechanical and Industrial Engineering, 18(1), 89–97. https://doi.org/10.59038/jjmie/180107
Dubey, D. K. (2026). Design and Optimization of Forced Transducers for Energy Harvesting from Ambient Mechanical Vibrations, Wind, and Ocean Waves. Journal of Alternative and Renewable Energy Sources, 12(1), 1-10.
Gkoumas, K., Petrini, F., & Bontempi, F. (2017). Piezoelectric vibration energy harvesting from airflow in HVAC (heating, ventilation, and air conditioning) systems. Procedia engineering, 199, 3444-3449.
Hammid, A., & Surjosatyoe, A. (2018). The Use of Flow-Induced Vibration as An Alternative Source of New Power Plant in Indonesia. 01017, 1–6.
Hu, G., Tse, K. T., Wei, M., & Kwok, K. C. S. (2020). Experimental investigation of flow-induced vibration energy harvesting at low wind speeds. Experimental Investigation of Flow-Induced Vibration Energy Harvesting at Low Wind Speeds, 211, 112726. https://doi.org/10.1016/j.enconman.2020.112726
Indah, N., Yunas, J., Hamzah, A. A., Latif, R., Sudrajat, N., Hamidah, I. (2023). NoStructural performance of PDMS-based planar membrane for electromagnetic vibration energy harvester. International Journal of Nanoelectronics and Materials, 16, 385–393. https://doi.org/10.58915/ijneam.v16iDECEMBER.419
Jiang, W., Li, Y., Ma, X., Wang, Y., Chen, L., & Bi, Q. (2022). Exploiting internal resonance to improve flow energy harvesting from vortex-induced vibrations. Journal of Intelligent Material Systems and Structures, 33(3), 459-473.
Kumar, R., Mishra, S., & Yadav, A. (2022). Effect of bluff body geometry on vortex-induced vibration energy harvesting. Journal of Fluids and Structures, 108(10341). https://doi.org/10.1016/j.jfluidstructs.2021.103471
Kurniawan, I., Ichwani, R., Fionasari, R., Batubara, A., & Huda, A. (2022). Indonesia’s renewable energy outlook: what to expect in the future renewable energy of Indonesia. a brief review. Elkawnie: Journal of Islamic Science and Technology, 8(2), 298-313.
Li, S., Tang, L., Yang, Y., & Dowell, E. H. (2022). Broadband electromagnetic energy harvesting from vortex-induced vibration using nonlinear coupling. Mechanical Systems and Signal Processing, 168, 108642. https://doi.org/10.1016/j.ymssp.2021.108642
Lian, J., Yan, X., Liu, F., & Zhang, J. (2017). Analysis on Flow Induced Motion of Cylinders with Different Cross Sections and the Potential Capacity of Energy Transference from the Flow. 2017. https://doi.org/10.1155/2017/4356367
Mashuri, U. R., Hidayat, M. N., Efendy, B. D., & Subekti, S. (2024). FFT-based analysis of throttle body misfiring vibration. JTTM, 5(2), 230–237. https://doi.org/10.37373/jttm.v5i2.1107
Roundy, S., Wright, P. K., & Rabaey, J. (2003). A study of low level vibrations as a power source for wireless sensor nodes. 26, 1131–1144.
Shaker, M. R., Eluri, P. R., Ayele, F., & Chang, B. (2026). Practice and Feasibility of Energy Harvesting Technologies in Civil Infrastructure: A Comparative Review. Sustainability, 18(4), 2055.
Subekti, S., Guntur, H. L., Djanali, V. S., & Syaifudin, A. (2024, October). Experimental identification an elastically supported cylinder under free vibration using the Hilbert and wavelet transform. In AIP Conference Proceedings (Vol. 3098, No. 1, p. 020037). AIP Publishing LLC.
Subekti, S., Guntur, H. L., Djanali, V. S., & Syaifudin, A. (2022). Simulation and dynamic system modeling of an elastically supported rigid cylinder for vibration energy harvesting. In Recent Advances in Renewable Energy Systems, 61–68. https://doi.org/10.1007/978-981-19-1581-9_7
Subekti, S., Guntur, H. L., Syaifudin, A., & Hendrowati, W. (2025). The influence of electromagnetic position on the elastically supported cylinder due to the influence of wind speed as an alternative energy. In AIP Conference Proceedings (Vol. 3320, No. 1, p. 050004). AIP Publishing LLC.
Suryadi, A., Subekti, S., & Indah, N. (2024). Investigation of harvesting energy vibrations due to the feed process on milling machines. JTTM: Jurnal Terapan Teknik Mesin, 5(1), 83-89.
Syahputra, M. N. A. F., Subekti, S., & Indah, N. (2024). Effect of eccentric mass on rotor dynamics as a source of harvesting energy vibration. JTTM: Jurnal Terapan Teknik Mesin, 5(1), 54-61.
Tang, B., Wang, J., Yu, X., Yang, H., Bai, R., & Tan, W. (2026). Energy harvesting of cylindrical FIV under multi-prism wake. Renewable Energy, 256, 123918.
Wang, Z., Chen, J., & Yang, Y. (2022). Flow-induced vibration energy harvesting: A review of transduction mechanisms and system performance. Renewable and Sustainable Energy Reviews, 158(112130). https://doi.org/10.1016/j.rser.2022.112130
Weinstein, L. A., Cacan, M. R., So, P. M., & Wright, P. K. (2012). Vortex shedding induced energy harvesting from piezoelectric materials in heating, ventilation, and air conditioning flows. Smart Materials and Structures, 21(4), 045003.
Wu, Y., Pang, Y., Liu, L., Ye, T., Wang, L., Zhang, Z., ... & Wang, N. (2026). Design and Optimization of an Electromagnetic Vibration Energy Harvester. Journal of Vibration Engineering & Technologies, 14(2), 54.
Zhang, Y., Liu, Z., Wang, X., & Li, H. (2024). Recent advances in flow-induced vibration energy harvesting: Mechanisms, optimization, and applications. Energy Conversion and Management, 297, 117793. https://doi.org/10.1016/j.enconman.2023.117793
Zhao, L., Tang, L., & Yang, Y. (2021). Enhanced performance of vortex-induced vibration energy harvesting by wake interference. Journal of Fluids and Structures, 103, 103266. https://doi.org/10.1016/j.jfluidstructs.2021.103266
Zhu, G., Li, S., & Yang, Y. (2023). Broadband vortex-induced vibration energy harvesting using nonlinear stiffness. Mechanical Systems and Signal Processing, 298, 117189. https://doi.org/0.1016/j.apenergy.2021.117189
Downloads
Published
Issue
Section
License
Copyright (c) 2026 Subekti, Paduloh, Mochamad Saidiman

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Proposed Policy for Journals That Offer Open Access Authors who publish with the Elkawnie journal agree to the following terms:
a. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access).



