Design of a 1-phase Axial Flux Type Generator with a Variation of Winding on a Star-Shaped Stator

Authors

  • Muhammad Ikhsanudin Nahdlatul Ulama University Yogyakarta
  • Irwan Novianto Nahdlatul Ulama University Yogyakarta
  • Bledug Kusuma Prasaja Nahdlatul Ulama University Yogyakarta

DOI:

https://doi.org/10.22373/crc.v8i1.19658

Keywords:

Generator Axial Flux, Winding, Stator, Voltage

Abstract

A single-phase axial flux generator with a star-shaped stator is required to explore the optimal use of rainwater energy as a renewable energy source. Untuk eksperimen, jumlah coils dan diameternya diubah. 25 coils dan 50 coils with 0.4 mm diameter and 25 coils and 40 coils with 0.5 mm diameter were designed. Generator performance will be tested under load and no load conditions at 600 rpm to 2000 rpm. The test results indicate that, for a single-phase axial generator running at 2.4W output conditions, increasing the number of windings impacts the voltage induced by the generator and that the number of stator windings influences the quantity of induced voltage, current, and power. Test findings with various winding variations, employing a 4.8V 0.5A or 2.4W light bulb load, demonstrate that an increase in winding count leads to an increase in electrical output

Downloads

Published

2024-03-02

Issue

Vol. 8 No. 1 (2024)

Section

Articles

License

Authors who publish in this journal agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

  2. The Journal uses license CC-BY-SA or an equivalent license as the optimal license for the publication, distribution, use, and reuse of scholarly works. 

  3. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

  4. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).