Analisa Perancangan Filter LCL Pada Penyearah PWM Satu Fasa Full Bridge
DOI:
https://doi.org/10.22373/crc.v1i2.2082Keywords:
controlled rectifiers, PWM rectifiers, LCL filter, harmonicsAbstract
Electronics devices need a direct current power supply although now only one alternating current power supply is available. Therefore, ac-dc converters which can convert an alternating current power supply to a direct current power supply will be needed. However, the use of this ac-dc converters will cause distortion in the form of current waves which are called harmonics. This harmonics can fault the work of the other electric devices which are attached to the same power source. Therefore, it is recommended that the harmonics generated by rectifiers should be under IEC 61000-3-2 standard. In this research will the reduction of harmonics by using LCL filter. At load of 2 kW, R of 5 ï—, L of 0,05 H at PWM rectifiers single phase full bridge with RL load produce the third harmonics current of 2.57 amperes, the installed LCL filter produces the third harmonics current of 1.26 amperes. According to IEC-61000-3-2 standard, the allowed third harmonics current is 2.3 amperes.Downloads
Published
2017-11-02
Issue
Section
Articles
License
Authors who publish in this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
The Journal uses license CC-BY-SA or an equivalent license as the optimal license for the publication, distribution, use, and reuse of scholarly works.
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).